Synergy Tie Rod Boot

Add to compare added to comparison table.

Synergy tie rod boot.

Heavy duty tie rod for jeep jk wranglers bent similar to factory bar to clear sway bar mounts made from 1 3 8 4130 chromoly and heat treated for maximum strength 200 stronger than stock tie rod synergy double adjuster sleeve. Measuring for dust boots. Synergy hd metal on metal tie rod end boot. With age or wear it is possible the boot may be damaged or torn allowing dirt into the grease.

The polyurethane is flexible and will stretch slightly. Replaced them with new polyurethane ones purchased from simpson family jeeps. This part is designed to limit tre misalignment specifically addressing tie rod flop commonly associated with hydro assist applications. Synergy hd metal on metal tie rod end boots are made from tear wear resistant black nbr and come with retaining springs.

Synergy jeep jk hd metal on metal tie rod end boot for 4131. Energy suspension s recommendation appears to be to use a part that is approx 0 5 1 0 mm smaller than the diameter you need. Measure your tie rod end or ball joint to find the exact dust boot that will fit your part. Really needed to replace two neglected tie rod boots on my 1995 wrangler yj.

The synergy low misalignment tie rod end tre dust boot has been designed to exclusively fit synergy 4134 l 4136 l and 4138 l tre s used in synergy dodge ram tie rods. Fits 4131 l 4131 r 4133 l 4134 l 4135 l 4135 r 4136 l 4137 l. If replacing your tie rod is not possible you may be able to clean it well grease it and install a new tie rod boot. A tie rod boot fits over the stud on the tie rod end to keep dust and debris out of the grease.

Allows adjustment of tie rod length without removing it from the vehicle strongest jeep jk tie rod on the market. Dimensions a and b.