Testing Garage Door Sensors

Do not handle them more than necessary or you might well put them out of alignment.

Testing garage door sensors.

Sometimes the sensor may be beyond repair due to wear and tear and in such a case your best bet is to replace the garage door sensor with a new one. Modern day garage door safety sensors are usually led and if the sensors are aligned correctly with the two beams connecting they should light up green. If something goes wrong with the sending eye the receiving eye will shut off also. Communication wiring is often more complicated than a wire and a wire and will vary according to the output of your sensor and your control system.

If any object blocks the path of the infrared sensors the garage door opener will not activate or will reverse if operating. The garage door is one of the most prominent parts of our house and they deserve equal care. Test the sensors ensure that the door is open and activate the opener. If the lights are turned on for both sensors then you can rule out a problem with the power supply.

The latest garage door sensors are technologically advanced and even allow you to control the opening and closing through an app on your smartphone. Whenever there is an obstruction the garage door will automatically reverse before causing any damage. Garage doors may display a variety of symptoms if sensors need attention. A lack of power supply is one of the most common causes of a malfunctioning garage door sensor.

The replacement safety sensors project an invisible light beam across the inside of the garage door to prevent accidents and are required for safe use of all chamberlain garage door openers. If the lights are off in one or both sensors however it points to an issue with the power supply. Here s a quick way to test the receiving eye to see if there is a problem. Connect the red probe to the wire going to the sensor and connect the black probe to the ground wire going to the sensor.

You can choose to press the close button located on the wall of the garage or the remote button. Press the button that closes the garage door on the garage wall or on your remote. Take a clean cloth and very gently wipe them in case they have accumulated dust or residue of some sort. The second line of defense is a set of infrared sensors which should be mounted 4 to 6 above the floor on each side of the garage door frame.

Look for small led lights on the sensors. If the garage door closes it indicates that the sensors are not functioning.