4 5 ground and floor surfaces.
The ada discusses ground and floor surfaces in section 4 5.
Ground and floor surfaces.
Floor or ground surfaces of ramp runs shall comply with 302.
Changes in level other than the running slope and cross slope are not permitted on ramp runs.
4 1 2 accessible sites and exte rior facilities.
Ground and floor surfaces along accessible routes and in accessible rooms and spaces including floors walks ramps stairs and curb ramps shall be stable firm slip resistant and shall comply with 4 5.
405 4 floor or ground surfaces.
Guide to the ada standards 1 firmness stability and slip resistance 302 1 technical bulletin.
Swinging door and gate surfaces within 10 inches 255 mm of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door or gate.
Ground and floor surfaces 1 technical bulletin.
4 5 2 changes in level.
Ada standards for accessible design 28 cfr part 36.
Any occupiable floor less than one story above or below grade with direct.
Both section 4 5 1 of the 1991 standards and section 302 2 of the 2010 standards require that floor or ground surfaces along accessible routes and in accessible rooms and spaces be stable firm slip resistant and comply with either section 4 5 in the case of the 1991 standards or section 302 in the case of the 2010 standards.
4 5 2 changes in level.
4 5 ground and floor surfaces.
Access aisle of at least 60 inch width must be level 1 50 maximum slope in all directions be the same length as the adjacent parking space s it.
Parts creating horizontal or vertical joints in these surfaces shall be within 1 16 inch 1 6 mm of the same plane as the other.
4 5 1 general ground and floor surfaces along accessible routes and in accessible rooms and spaces including floors walks ramps stairs and curb ramps shall be stable firm slip resistant and shall comply with 4 5.
Justice under the americans with disabilities act of 1990.
New construction and 4 1 6 parking and passenger loading zones.
The ada discusses ground and floor surfaces in section 4 5 where they say in general that.
2013 forest service outdoor recreation accessibility.
4 5 2 changes in level changes in level up to 1 4 in 6 mm may be vertical and without edge.
302 1 floor or ground surfaces.
Feature built in or applied to walking surfaces or other elements to warn visually impaired people of hazards on a circulation path.
Ground and floor surfaces along accessible routes and in accessible rooms and spaces including floors walks ramps stairs and curb ramps shall be stable firm slip resistant and shall comply with 4 5.
The clear width of a ramp run and where handrails are provided the clear width between handrails shall be 36 inches 915 mm minimum.